How to protect the electromagnetic flowmeter to extend the use of time

　　The obvious feature of electromagnetic flowmeter is that the data measurement is relatively accurate, which can provide data parameter reference for enterprises and help enterprises formulate future production plans. The equipment has good quality and can provide more accurate measurement values ​​after being manufactured and put on the market. The equipment measurement is relatively stable and can be applied to various product energy production measurement, which is welcomed by corporate customers.

　　Only when the electromagnetic flowmeter is correctly installed can the equipment play a great role. Before installing the equipment, the staff must clean the impurities and dirt in the pipeline to ensure that the inside of the pipeline is clean and tidy, and that the flow material in the pipeline can flow freely. If there are more impurities and residues in the pipeline, before installing the equipment, in addition to removing the impurities and residues, it is also necessary to install a layer of filter in front of the equipment to filter out all the impurities and residues in the pipeline. After the impurities and residues are completely filtered, the water quality in the pipeline can be ensured to be clear and clean.

　　Clear and clean water will not affect the measured value of the equipment, nor will it cause damage to the measuring tools. Before installation, the valves behind the front valves of the pipeline need to be opened to prevent a large amount of fluid from impacting the equipment turbine and causing damage to the equipment turbine. Be especially careful when installing the equipment. A slight mistake may cause the equipment measurement to fail to complete normally.

　　There are some things you need to pay attention to when using the electromagnetic flowmeter. The device cannot share the same line system with the high-voltage lines. Sharing the lines will cause large deviations in the device data measurement. The device should not be installed near other lines to avoid mutual interference between the lines.