What are the installation points of battery-powered electromagnetic flowmeter?

　　1. The installation position of the battery-powered electromagnetic flowmeter can be selected according to your needs, and the sensor can be tilted or vertically installed. But regardless of the form of installation, it should be noted that the axis of the two electrodes must be roughly in the horizontal direction.

　　2. Note that the battery-powered electromagnetic flowmeter sensor should be installed to ensure that the measurement pipe is full of the measured medium, there can be no non-full pipe or bubbles gathered in the measurement pipe phenomenon. So do not install the sensor in the pipeline at a high place, but to be installed in the lower to. Instead, install the sensor on a lower, upward sloping pipe. When installing on the vertical pipeline, do not install in the liquid flow direction from top to bottom, but to be installed in the pipeline from bottom to top. Do not install the sensor at the inlet of the pump, because it is easy to form a vacuum here, affecting the measurement effect.

　　3. When the sensor, pay attention to the direction of the arrow on the sensor, which refers to the direction of liquid flow.

　　4. The sensor of the battery-powered electromagnetic flowmeter is not sensitive to vibration, but if it is installed in a place with strong vibration, it needs to be supported on the second side of the pipe where the sensor is installed.

　　5. The measured medium is seriously dirty liquid over the liquid easily scaled in the pipeline, you can install the sensor on the measuring pipe to add a bypass pipe, in order to facilitate the dismantling and cleaning.