Split electromagnetic flowmeter price

Price of split electromagnetic flowmeter

1. Overview: The main components of the sensor of this product are: measuring tube, electrode, excitation coil, iron core and yoke shell. 2. Features: 1. The electromagnetic flowmeter is almost not affected by changes in fluid temperature, density, viscosity, pressure and conductivity when measuring liquid flow. 2. The DN450 electromagnetic flowmeter has only flowing parts in the measuring tube, no pressure loss, and the straight pipe section requirements are low. 3. Judging from the current production technology, the nominal diameter of the electromagnetic flowmeter can reach dn15 ~ dn3000, which can basically meet various on-site needs. Moreover, there are many choices for sensor lining and electrode materials of electromagnetic flowmeters. 4. The converter adopts excitation mode, which has low power consumption, stable zero point, high accuracy, and the accuracy is basically maintained at level 0.5. The flow range can reach 15:1. 5. The converter of the electromagnetic flowmeter can be combined with the sensor in various ways, such as an integrated type or a split type. 6. The converter adopts 16-bit high-performance microprocessor and 2x16lcd display, which makes parameter setting easy and programming reliable. 7. The electromagnetic flowmeter is a bidirectional measurement system with three built-in totalizers: forward total, reverse total and difference total. It can display the flow and reflux flow, and has a variety of outputs: current, pulse, digital communication, hart, etc. 8. The converter adopts surface mounting technology (smt) and has self-check and self-diagnosis functions.

Split electromagnetic flowmeter price

3. The installation steps are as follows: ▲DN450 electromagnetic flowmeter can be installed on vertical pipelines, or on horizontal or inclined pipelines, but the requirements The center line connecting the two electrodes is in a horizontal state. ▲The medium should flow fully into the tube at the installation position to avoid the tube being full and gas adsorbed on the electrode. ▲When the medium at the installation location of the flow meter is not full of the pipe, you can raise the pipe at the rear end of the flow meter to fill the pipe. It is strictly prohibited to install the flow meter at pipe points and water outlets. ▲The length of the straight pipe section before and after the flow meter: the front section ≥10DN, the rear end ≥5DN (DN is the pipe diameter) ▲Flange connection, the matching flange is spot welded to the pipe, and the bolts are connected to the flange on the body. Weld again. ▲Additional type: First weld the two flanges on the body and the pipe, install the flow meter together with bolts and nuts, and then perform spot welding. 4. Model selection: Factors that should be considered when purchasing an electromagnetic flowmeter: ▲ First, determine what medium the flowmeter measures, such as water, gas, steam, etc. Different types of measuring instruments should be used for different measurement media. ▲Understand the measurement conditions of the measurement medium, such as pressure, temperature, whether there is corrosion or whether there are any special measurement requirements. ▲Understand the measurement accuracy required. ▲Pay attention to the stability of the instrument. After all, if the instrument has poor stability, it cannot be used. ▲Find out the price of the instrument you can accept.